Earlier this week I finally completed building IDEX printer with two X-steppers and while I am waiting for 2nd e3d hotend to arrive, I started to print with single print-head (X1); ditto mode is switched off in configuration file.
I mentioned that unused X2 stepper is getting warm during the prints, i.e. it is enabled and getting power. I was not able to find a GCODE that would disable particular stepper. As per https://reprap.org/wiki/G-code M18 and M84 disable all steppers.
So, I'd like to ask if anyone looked at this issue and found a way to disable/power off unused steppers without unplugging them.
Thanks
