Greetings
Regarding my HE3D K200 Delta
Probe with offset of 6.63
After getting the bed level manually, when using G32 S2 P0, after the probing is complete,
the Z_Max_Length has been changed. Always to a lower number. For example, it should be
303.350. After the G32, it is changed to 303.318.
With the Z height lowered, upon printing, the nozzle becomes a glass cutter. :(
I have added M500 after the bed-leveling procedure, but haven't found that to be helpful yet.
I have tinkered with the Z Probe offset, even though when I manually check it, I find that the
switch clicks at 6.43mm's above the bed.
Z0 is in fact as close to zero as possible.
I've tried G29. That does nothing. And I believe I have read that Repetier doesn't level using this code.
I've tried G32 S1 P0, and this code doesn't change the Z_Max, but I still have a glass cutter upon
printing.
Any direction would be great