BiOzZ I have the firmware set to use Bed Leveling Method 1 (the grid method) with 2 repetitions but when i use G29 it probes the bottom left corner, bottom right corner and top center and homes it self without probing in a grid pattern Am i using the wrong GCode? configuration issue?
BiOzZ Repetier said: Yes, wrong code. We are not marlin:-)G32 S2is what you want to run. This worked to start probing, but i have a new problem and that is it appears to be doing my 5x5 grid at a 45* angle (diagonally) and causing the X axis to collide with the frame
BiOzZ A little update, using the repetier host software and its bed leveling heatmap the bed leveling works just fine, but when i use G32 S2 i get the angled problem and you cant save any corrections from the host software's tool
Repetier You get the parallelogram if points are in wrong order. P1 is left front edge, P2 the right front and P3 the left back. P1-P2 and P1-P3 form the parallelogram.
