Diamond Mixedcolor Extruders

Arnold

Hello,

If i adjust my extruders, they have different Resolution.
For example: Feed 100mm on every extruder.

Result:
EXT1: 100mm
Ext2: 101mm
Ext3: 110mm

Is there any posibility to setup the Resolution for each extruder ?

This setting was gone after i set Mixing Extruder = 1

Thanks for Help

Arnold

Hello again,
its ok. in configuration.h i still can change the setting. Only on the webpage configuration this setting is gone.

thanks

Repetier

In config tool disable mixed extruder to change them and enable it back then. Older versions only used first resolution but that is now fixed.