I am having problems installing Viki 2 on my Rambo v1.4 board.
I am confused about the pins on the board.
on DisplayList.h in the repetier firmware these are the pins related to the LCD display:
#elif MOTHERBOARD == 301 // RAMBO
#define SDCARDDETECT 72 // sd card detect as shown on drawing#undef BEEPER_PIN#define BEEPER_PIN 33// Display A0#define UI_DISPLAY_D5_PIN 70// Display CS#define UI_DISPLAY_RS_PIN 71#define UI_ENCODER_A 85#define UI_ENCODER_B 84#define UI_ENCODER_CLICK 83#define UI_RESET_PIN -1#define RED_BLUE_STATUS_LEDS#define RED_STATUS_LED 22#define BLUE_STATUS_LED 32
However there are instructions from this document:
<a rel="nofollow" target="_blank" href="https://reprap.org/mediawiki/images/e/e2/Rambo-LCD.pdf">https://reprap.org/mediawiki/images/e/e2/Rambo-LCD.pdf</a>
They tell to add the pins in the arduino environment. This confused me.
Also none of the pins match then pins in the Rambo schematic, https://reprap.org/mediawiki/images/7/75/Rambo1-1-schematic.png .
So I do not know how should I connect my Display, I am terribly confused.
