Repetier said:
This picture happens typically if you have cross talk to x axis. One simple solution and test would be to disable endstop test during printing. In repetier-firmware this would be ALWAYS_CHECK_ENDSTOPS which you would set to 0 in configuration.h.
Could also be a motor overheating or blocking or loosing steps.
<a target="_blank" rel="nofollow">marcoolivo</a> said:
Hi, I have the Repetier Host V2.1.2 in my Tarantula, always when I printing something the printer start in one position of the heat bad and after some layers they change alone for the side position. Could you can help me, I´m new in 3D printer.Thanks
Hi, thanks for the answer, Unfortunately I have bad skill for change the configuration, I imagine that you talk about the Firmware EEPROM in the Repetier ? Coul you please show me what line that I need to change for "0". In the firmware EEPRON that appear in my versio (2.1.2) for exemple not show the Extruder setting, they missing in my versio, I traied to calibrated the speed of filament. Thanks a lot
