Repetier What is the issue with that? Just do it if your firmware supports it. All you need is place object on left side and add acivate ditto mode gcode.
Fox104 I was concerned that you do not specify the distance between the carriages - is where he takes it?
Repetier You have to take care of that yourself. That is why I said position it left and not center. Where an dhow wide it can get depends on firmware and settings I think.
Fox104 Dont work. Model in left side. After homing enable ditto mode and all go to left.......https://www.youtube.com/watch?v=Ext7ucSvofQ<br/>
Repetier What firmware do you use? I only know our firmware in ditto mode and there left starts at 0.
Repetier Are there any negative x moves in your gcode? You could test manually what range is achieveable and as long as you keep inside that area printing should not hit the endstop. Normally you start at x min and can move 50% of width to the right.
Fox104 No negative moves.G90M82M106 S0M140 S100M190 S100M104 S250 T0M104 S250 T1M109 S250 T0M109 S250 T1G28 ; home all M280 S1 ;G92 E0G1 E-2.0000 F900G1 Z0.650 F1002; process Process1; layer 1, Z = 0.150T0; tool H0.150 W0.528; skirtG1 X51.478 Y87.563 F6000G1 Z0.150 F1002G1 E-0.1000 F270G92 E0G1 X51.545 Y87.526 E0.0025 F1200
