PMGZED Hi i have update my 3D Printer and have add a second Extruder now i have the Problem thats Heater2 stop heating to early if i set 220c then the Control led go off by 200c Extruder1/Heater1 work fine
Repetier Check eeprom settings for extruder 2. Normally 20°C before target temp the heat controller takes over, so I assume the values set there lead to not heating.
PMGZED Hi Repetier thx für the fast answeri have copy all Settings from Extruder1 to Extruder2 and now its work fine :-) the setiing "extr.2 heat Manager" was on 255 now it is 3 think this was the mistakethx thx thx now i can print with dual Extruder :-)
