Re-Arm Smoothieware TCP/IP

oldtimmer

I am trying to use tcp/ip in Repetier Host
Settings
IP Address 192.168.X.X
Transfer Protocol Autodetect
Port 23
Receive Cache Size 1024
Communication Timeout 40

I can move, home,turn on hotends and bed with no problems after increasing the Receive Cache Size from 147 to 1024.
But when I go to print it homes ok then starts to print and stutters then smooths out and prins fine after the first layer.
any ideas

oldtimmer

Seems the slicer I was using was the problem.
I sliced the model with cura and everything worked.
I did have to increase the cache size from 147 to 2096 in printer connection settings

Repetier

Not sure what smoothieware cache size can receive. Over serial the limit for firmwares is normally 127 byte.