Zaxis moving when i try to move x and y-axis

PmK

I want to upgrade my RAMPS/Mega to RADDS/Due. RAMPS was working without any problems. Yesterday ive wired everything. When i now start homing for all everything is fine. But when i then move the x-axis or the y-axis with repetier-host the z-axis is moving too and when i move the z-axis i can hear that the x-axis is moving too. My first attempt was RADDS/udoo-quad and i had the same behavior like now with arduino due. Could anyone help me?

Repetier

Try the following. Home XYZ and send M114
You get some coordinates in log. In printer settings->Shape set these coordinates as homing coordinates.

This normally happens if you did not enter the right homing coordinates in host.

PmK

There was a problem with the eeprom.. ive reset it and now everything works fine.
The eeprom makes many things really complicated for a newbee sometimes :-D