AD595 or 597

ta1dr

hello All

I want to use termocupler for bed and I have AD595 board I used ths board merlin firmware and ramps connect aux1 A3 pin also change #define TEMP_1_PIN 3

but same board same ramps and repetier firmware also same change pin I didnt read temparature reading "def" on LCD

how can I connect ?

Ahmet

Repetier

Watch out that repetier uses different pin naming. TEMP_1_PIN is normally used for heated bed. Extruder uses TEMP_0_PIN by default.

ta1dr

thanks for answer

I solved ....

Iwant to use for heated bed, you right TEMP_1_PIN used but ad597 out mV connect to direct a/d port

I used AUX1 terminal on ramps.... and connect A3 pin

pins.h

...

....

motherboard==33 also TEMP_1_PIN change assing 3 and work very well....

regards..