Problems with 2 Extruders

exploid

Hello,
i have installed 2 Extruders but my Cura do Strange things.
Cura Create a second object.
can you help me ?

i got the same slice if i set my offset´s to 0

Repetier

The second object is called Pillar and is used in 2 color prints to refill the unused extruder so print comes out fine. That is good to have and added by CuraEngine.

exploid

can i deactivate it ?

exploid

ok now i have found it thank you :)

exploid

now i got an other problem,
if i slice with 2 extruders like this picture on top and want to print repetier dont heat the secound extruder

; Default start code

G28 ; Home extruder

G1 Z15 F{Z_TRAVEL_SPEED}

M107 ; Turn off fan

G90 ; Absolute positioning

M82 ; Extruder in absolute mode

{IF_BED}M190 S{BED}

; Activate all used extruder

{IF_EXT0}M104 T0 S{TEMP0}

{IF_EXT1}M104 T1 S{TEMP1}

G92 E0 ; Reset extruder position

; Wait for all used extruders to reach temperature

{IF_EXT0}M109 T0 S{TEMP0}

{IF_EXT1}M109 T1 S{TEMP1}

Repetier

What does the generated start code look like? Are the T1 parts missing or set to 0?

exploid

T1 parts are missing

;Generated with Cura_SteamEngine 15.01

; Default start code

G28 ; Home extruder

G29 ; Autobed Leveling

G1 Z25 F100

M107 ; Turn off fan

G90 ; Absolute positioning

M82 ; Extruder in absolute mode

M190 S50

; Activate all used extruder

M104 T0 S200

G92 E0 ; Reset extruder position

; Wait for all used extruders to reach temperature

M109 T0 S200

;Layer count: 9

;LAYER:0

M107

G0 F9000 X68.900 Y68.900 Z0.400

;TYPE:SKIRT

Repetier

Ok, looks like host thinks you did not select a second object with extruder 2 in object placement. If that is not the case it will not send a second stl for that extruder and only activate heater 1.

exploid

ok how i can change or fix that

Repetier

Select extruder 2 for second stl file in object placement and slice again.

exploid

i have do that wait i show you some screenshots ;)

exploid

the Startcode is still :

;Generated with Cura_SteamEngine 15.01

; Default start code

G28 ; Home extruder

G29 ; Autobed Leveling

G1 Z25 F100

M107 ; Turn off fan

G90 ; Absolute positioning

M82 ; Extruder in absolute mode

M190 S50

; Activate all used extruder

M104 T0 S200

G92 E0 ; Reset extruder position

; Wait for all used extruders to reach temperature

M109 T0 S200

;Layer count: 9

;LAYER:0

exploid

ok i found the problem the solution is i pick the wrong Printer config <span>:sweat:</span>