Hello,
I have built an core xy 3d printer with hypercube motion system – radds+due+tmc2130
and 30*30 cm bed +repetier 1.0 fwm and no lcd.
After reading the manual on the site and applied the
following settings
a.
Auto level can be activated with G32 S2 – and it
only compensates if bed it tilted on sides (for exemple left side of the bed it
lower than right side of the bed)
b.
Distortions can be activated with M323 S1 and
G33 to get matrix - and it compensates if bed it has bumps (for exemple if
midle of the bed it higher than bed margins…)
With n*n matrix auto level-software correction i realized
that autolevel dont work, mening than: even if i get corection matrix it does
not using it when printing, and when activating distorsion printer makes prints
tilted to the right.
Z probe it used for auto level and z home and it connected
to z min end stop (z max it disabled), xy homes towards xy min endstops
(selected option from configuration tool).
My questions are :
1.
For auto level n*n matrix P1=XY home? or it
matters where is located?
2.
For distorsion X/Y Min/Max need to start from
same coordinates as auto level (meaning that if P1= XY home for auto level -
for distortion matrix first measuring point need to be same point as P1 auto
level)
3.
Before or after G32 S2 or G33 need to use another G/M code (except G28)?
4.
Doese repetier host/hight map works for core xy
or only for deltas ?
Thank you
