Dual x steppers

Portex

Hello Everybody

I'm new here and hope I'm on the right section.

I have a problem with the Firmware repetier 1.0.0, i selected there dual x steppers (EXT1), but i cannot get the second motor to run, also swaping over to EXT0 is not helping, wiring and the drivers are OK.

Does somebody know this problem?

kind regards
Portex

Repetier

Dual X stepper means extruder 0 uses first x stepper and extruder 1 second x stepper motor. I guess you wanted mirror x stepper so both turn the same time.

Portex

Yes exactly this i want to do.

Is there a way to do this?

Repetier

Yes, do what I said. Use mirror x and not dual x and it will work.

Portex

Thank you verry much, i haven't seen this setting first