I use Ramp1.4 with Repetier 0.92.9 for a x,y plotter.
The plotter ist hanging on a wall.
Speed is low 15mm/s and acceleration 10mm/s2.
I want that the plotter is slow and quiet.
The motor sound is good, but ..
There is a noise (like "tak"), if one G1 or G0 commands ends and the next one starts (SD-card).
There is no noise during the command itself.
The noise is not loud, but louder than the motors.
I do not remember this sound from my 3D-printer.
I changed speed, jerk and acceleration, but this does not influence the "tak" between the commands.
What can be the reason?
Does the motor stop shortly between the commands?
Thanks!