rixstaa said:
Im sort anet out and il check back im fed up of this 1 I got a bunch of vseries, nema 23s 17s and 14s but cant even get this piece of crap to work so maybe im in wring hobby or something cuz every one talk like they know what they talking about, you buy and do what they say and it turns out bs
I can't help but respond to this post, given I am a tronXY X1 owner - apologies if I'm resurrecting it, but I feel it's important for anyone else that might have this issue.
Firstly, TronXY made this printer, not Repetier, blaming them and their attempts at helping you is just, insulting, I understand how stressful these issues can be to a beginner, but it doesn't help.
Secondly, This model uses roughly 100 steps/mm, 400 is to put it bluntly - insane and would never work. Using such high settings may have burnt out the voltage regulators, and if not could permanently damage the motors.
From what settings I can see in your firmware, everything is wrong - which means you changed everything to something wrong - I'm guessing you attempted to install a custom firmware or alike?
thirdly, tuning down the pots will prevent the motors from moving at all, Like most TronXY parts they are cheap and low quality, they require more voltage to move, not less.
The factory calibrations are almost always correct and I have never needed to replace the pre-loaded firmware.
Finally, Video is generally very unhelpful, especially shaky video that doesn't show much of the printer itself.
I apologies if I sound dismissive, it's not my intention - I'm just shocked at how the printer ended up in this state, I'm going to guess bad advice by people who own different models.
If by some miracle you haven't thrown the entire thing in the bin my now, I'm attaching a screenshot of my firmware settings, please note these are modified by only the smallest amount for calibration purposes; thus should help you and any other users.
For all TronXY users, The TronXY manual explaining how to build and setup the printer was included on the SD card - I do not suggest deviating from it at all if possible, it is cheap and chineese and has very little tolerance for errors on the part of the user..