jerk

Hi

I did the SLA printer

control Galve

what values I need to put, that was constant speed

if print the square it on the corners laser makes a small stop . and a laser at an angle of more light, and not a lot of concave side of inside

#define MAX_FEEDRATE_X 30000

#define MAX_FEEDRATE_Y 30000

#define MAX_FEEDRATE_Z 2

#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_X 30000 ????

#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Y 30000 ????

#define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_X 300 ????

#define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_Y 300 ????

#define MAX_JERK 20 ?????

thanks for the answer

Elshad

foto

Start speed is 50% of xy jerk or commanded start speed, whatever is lower.

Thanks for the answer

I realized it, I was reading your site

but I need to start speed 100%

that it is necessary to enter JERK 1 or 100 ?

Jerk is in mm/s not percent. So use your double start speed and hope the printer can handle that speed without acceleration.