jbaiao Hi!In my config, i put in "Probe start script" this:G1 Z3\nG28 X Y\nG1 X100 Y100\nG28 Z\nG1 Z3The behavior I want is as follows; 1- Lift the carriage 3mm upwards (avoid hitting anything before homing) 2- homing X and Y 3- Move the carriage in the middle of the table 4- homing Z 5- Lift the carriage 3mm upwards (not to have the inductive sensor active before auto leveling) 6 - starts the auto leveling processIt turns out that it is looped in G28 X Y and does not pass this.In the stable version it works.Any tips on how to work around this problem?
Repetier G28 is adding a lot of moves and troublesome sometimes. In general it is not good to have homing in probe start script. That is assumed anyhow. It is more for activating a servo etc, which is not needed with inductive sensors. Also this all interferes with probing where also positions are controlled.
MartinH 1 2 3 and 4 are all done automatically when you do a 'home' or G28, if you set homing order'z up, x,y,preheat z' and set pre raise z = allways using dev version of firmware
