IDOM Hi everyone!, Trying out the new version V2 of Repetier Host , after slicing the object doesn´t appear on screen , not by layers not by whole, it does show the trace moves though, than way I can see it did sliced.. Anyone with the same issue? when using V1 I had no problem whasoever..
IDOM IDOM said: Hi everyone!, Trying out the new version V2 of Repetier Host , after slicing the object doesn´t appear on screen , not by layers not by whole, it does show the trace moves though, than way I can see it did sliced.. Anyone with the same issue? when using V1 I had no problem whasoever.. Ok it seems there was the filament option turned off... it is ok now I think...
Anton1o IDOM said: Ok it seems there was the filament option turned off... it is ok now I think... Hi, I has the same invisible layers after slicing. Where this filament option is turn on?
Anton1o and just I find, that this is when slicing with Slc3R (on the picture above)And if use CuraEngine, the sliced as the below. So, I think, that I has accidentally off something. But don't know, where and what, if somebody can prompt, I would like it.
Repetier What you see in slic3r are only moves and no extrusion. This is likely to happen if you have selected the wrong g-code flavour e.g. mach 3 which uses A for extrusion and not E like fdm printer.
Anton1o Repetier said: you have selected the wrong g-code flavour Thanks, but in which place is that settings are?
Repetier Well, that is exactly what you saw so it was working:-) RepRap Firmware is your better choice.
romas Hi everyoneI have similar problem, after slice with slic3r, I see only object, not supports, for supports there are only moves. What can be wrongly set?
Repetier Please check the gcode. I guess it has no increasing E for support so it shows it as moves. Maybe you have selected wrong firmware flavour so it uses A/B instead?
epirie Hi I had the same problem No layers visible only the Travel moves. Found under config filaments that the check box for Disable Filament visualization was checked.
