angle correction Y tower delta printer

My X-tower is exactly 120 degrees from the Z-tower. However the Y-tower is 119 degrees from the Z-tower.

How do I correct this difference?

Thanks

Set Y angle to 229° so X-Y is 119° and Y-Z 121°.

Hi,

can I change this in eeprom settings?

If yes how and where.

What is the difference in eeprom between 'corr diagonal' and 'dealta radius' ?

Thanks again

Yes you can chane them all in eeprom.

Corr diagonal gets added to diagonal length. Delta radius is the horzontal radius when centered.