Disable Y Axis change during M600 Filament Change routine.

Doug40

The Configurator allows you to easily select the position to which the extruder will move when a manual filament change is requested by a M600 command (in the G-Code). What do you enter in the Configurator when you do not want an axis to move? For example, leave the Y axis where it is positioned when the print was interrupted, and move the other two axes to the filament change coordinates specified?

Repetier

It it works 99999 would indicate to ignore move for that axis.

Doug40

I tried 99999 and -1. 99999 drives the Y axis to max deflection from the home position when M600. -1 drives the Y axis to zero. Any other choices? I didn't see any Define statements that could be commented out.

Repetier

No, if that does not work the used function does not select ignore for the special 99999 value and you must define a good coordinate instead.