<font face="Arial, Verdana">Hello everybody</font>
<font face="Arial, Verdana">
</font>
<font face="Arial, Verdana">I'm building my first printer (delta )
</font>
<font face="Arial, Verdana">
</font>
<font face="Arial, Verdana">1 What are contacts for table adjustment motors?(mega 2560 + ramps 1.4</font>)
<font face="Arial, Verdana">2 What motors can be used? (stepper or servo)</font>
<font face="Arial, Verdana">3 Where to set up steps per mm (if servo degrees </font>per mm) wake up table?
