auto level disable

dan27

Hey all i have a tronxy x3 which runs repieter firmware ive looked everywhere i have auto level but im wanting to change to a glass bed like my other printer so i would like to disable the auto level but im pretty newbish when it comes to firmware

am i able to just use the sensor as a end stop or would i need to go back to a endstop switch

Repetier

- M320 S<0/1> - Activate autolevel, S1 stores it in eeprom

- M321 S<0/1> - Deactivate autolevel, S1 stores it in eeprom

- M322 - Reset autolevel matrix

you can use z probe also as z min but that is a bit difficult for some combinations. So make sure autoleveling at home pos works or use a homing order with temp. which allow setting homing coordinates for z so probe is above bed.

dan27

thank you i ended up mounting my z probe to my z mount which lets it level and stop right where i need it. ill be disabling auto level with those commands thankyou :)