z-probing N*N grid measuring but only measure 3 points

raymond

Finally get my z-probe working, and the configuration is like this.

// #################### Z-Probing #####################

#define Z_PROBE_Z_OFFSET 0

#define Z_PROBE_Z_OFFSET_MODE 0

#define UI_BED_COATING 1

#define FEATURE_Z_PROBE 1

#define Z_PROBE_BED_DISTANCE 10

#define Z_PROBE_PIN ORIG_Z_MIN_PIN

#define Z_PROBE_PULLUP 0

#define Z_PROBE_ON_HIGH 0

#define Z_PROBE_X_OFFSET 0

#define Z_PROBE_Y_OFFSET 0

#define Z_PROBE_WAIT_BEFORE_TEST 0

#define Z_PROBE_SPEED 10

#define Z_PROBE_XY_SPEED 150

#define Z_PROBE_SWITCHING_DISTANCE 1

#define Z_PROBE_REPETITIONS 1

#define Z_PROBE_HEIGHT 1

#define Z_PROBE_START_SCRIPT "G28 G1 z25 f5000"

#define Z_PROBE_FINISHED_SCRIPT "G28"

#define Z_PROBE_REQUIRES_HEATING 0

#define Z_PROBE_MIN_TEMPERATURE 150

#define FEATURE_AUTOLEVEL 1

#define Z_PROBE_X1 -30

#define Z_PROBE_Y1 50

#define Z_PROBE_X2 140

#define Z_PROBE_Y2 50

#define Z_PROBE_X3 -30

#define Z_PROBE_Y3 198

#define BED_LEVELING_METHOD 1

#define BED_CORRECTION_METHOD 0

#define BED_LEVELING_GRID_SIZE 5

#define BED_LEVELING_REPETITIONS 5

#define BED_MOTOR_1_X 0

#define BED_MOTOR_1_Y 0

#define BED_MOTOR_2_X 200

#define BED_MOTOR_2_Y 0

#define BED_MOTOR_3_X 100

#define BED_MOTOR_3_Y 200

#define BENDING_CORRECTION_A 0

#define BENDING_CORRECTION_B 0

#define BENDING_CORRECTION_C 0

#define FEATURE_AXISCOMP 0

#define AXISCOMP_TANXY 0

#define AXISCOMP_TANYZ 0

#define AXISCOMP_TANXZ 0

So the measuring points should be a 5*5 matrix,but my machine only measure three point,why?

Repetier

Did you use G32 S2? If you used G29 that is not bed leveling just measuring average height at 3 points!

raymond

Repetier said:

Did you use G32 S2? If you used G29 that is not bed leveling just measuring average height at 3 points!

GET IT，IT WORKS，THANKS