@ roko: i can move the arm till max 23 degree (0 degrees being flat) if i take the in account the 90mm radius.
so this is definitely not flat, but maybe it is already to close.
if i go for 0 degrees it really goes near the edge.. so like 105mm out.
at that moment the bottom of the slider is @ 55 mm from the frame (which is lower than the hotbed of course) so
for that height i should take like 60 mm?
i will set it like that for now, unless you let me know not to..
@ Repetier:
i set Z_probe_switching distance: to 1.6mm. just to have that little bit extra buffer.
the Z_probe_bed_distance: i set to 20mm
but when i try the start the bed height mapping few things go wrong.
1) at the start (home) the carriage crashes into the end stops even thought the drop after the homing is set on 10 mm, plus there is the extra drop on the x and y pillar because of the selection of 1e extruder. guessing approx. 5mm meaning it crashes into the end stop even though the 15mm height difference.
2) the first measurement seems to go perfect (goes up and down 3 times??? ) but afterwards it goes almost all the way back up. not just the 20mm
3) 2e measurement goes oke too, but after the first touch on the 3rd measurement it give fatal failure, while nothing seems to go wrong physically.
kind regards Matthieu
