Hi Repetier
Thanks for all previous responses
I now have another
problem. I am attempting to connect nema 23 stepper motors (8 wires
wired in series) to an arduino due board with the repetier firmware
installed. I used the on line firmware generator and uploaded it to the
board as far as I know successfully. I have tried to test the motors
but although there seems to be power going to them they do not respond
to move commands on the host software.
Do all the endstops, thermistors, heated bed and hot ends need to be connected before it will move?
Am I missing something in my attempt to connect this machine?
Thanks
