anyone has problem with radds 1.5+due command M84 and z-axis?

I've succesfully compiled and I run 0.92 on RADDS 1.5; but I noticed that the command M84 disable X and Y motors but not the one on Z.

It's equiped with drv8825.

Checked with the schematic (published on reprap.org) and the Z_EN pin is properly set to 15

Thx

Check you setting for this:

Prevent z stepper disabling on stepper timeout. (PREVENT_Z_DISABLE_ON_STEPPER_TIMEOUT)

thank u so much, I will test tomorrow when the printer come back to office, I will confirm

with z stepper prevent disabling off m84 work fine also for z

thanks