Setup auto bed levelling 3D Touch and Rumba Board.

wnillissen

I am trying too configure the Repetier firmware 0.92.8 using a Geeetech 3d Touch sensor on a Rumba board.The 3D Touch sensor is connected with 1 plug on the EXP3 connector pin2: +5 Volt, pin4: GND, pin6: PWM2 and other plug on the Endstop connector pin1: Zmax, pin2: GND.

Does any one know how to configure the Repetier Firmware and the G codes to operate the sensor?

Thanks,

wnillissen

shaiss

Did you sort this out? I'm going to start on this this week on my reprap. So curious if sins if the figuring out has already been done.

theohenrichs

Hi
I followed the manual --> https://www.antclabs.com/manual . The problem is - I think - that this manual is not correct for a Rumba board but more for Ultimakers. I have a feeling that the suggested changes in the pins.h is not correct for Rumba boards.
Does anyone have suggestions?
Thanks in advance
Theo