Run on Pause Not the Same as Filament Sensor Pause

lboucher

Hi All

Maybe i posted in the wrong forum.

This thread is over in the Repetier firmware section, but techincally the pause GCODE is being input into the server, so maybe its a serve issue.

Long story short, I want my pause function to do a relative move up of 30 mm.

This works when i hit the pause button on the webpage, but if the filament sensor causes the arduino to request a pause, then it goes to Z30 absolute.... Which crashed my printer into the print.

https://forum.repetier.com/discussion/2286/manual-pause-vs-filament-sensor-pause-not-working-right </div><div>