Z-Probing of Delat printer.

Hi Repetier:

I'm building a delta printer.

the board is Arduino Due with RAMPS-FD V2.

the repetier-firmware vision is 0.92.9.

#define BED_LEVELING_METHOD 1

#define BED_CORRECTION_METHOD 0

I followed the video "Z-Leveling for Delta Printers with Repetier-Firmware".

My step is (follow the video ):

M321

G131

M99 X0

M99 Y0

M99 Z0

G132 S1

G32 S2

G1 Z5

then "Tools"->"Bed Height Map"->"Measure Heights"， Result to Clipboard as follows:

X: -50.00 -25.00 0.00 25.00 50.00

y: 50.00 6.58 5.61 5.27 5.63 6.64

y: 25.00 5.60 4.63 4.37 4.72 5.69

y: 0.00 5.23 4.34 4.02 4.39 5.36

y: -25.00 5.56 4.70 4.38 4.69 5.58

y:- 50.00 6.58 5.68 5.41 5.65 6.47

G29 or G33 (I have test the two Command)

G1 Z5

then "Tools"->"Bed Height Map"->"Measure Heights"......

After all the steps,I execute the following command:

G1 X0 Y0 Z5 (the distance between nozzle and bed is 5mm)

G1 X50 (but the distance between nozzle and bed is above 6mm)

G1 X-50 (but the distance between nozzle and bed is above 6mm)

G1 Y50 (but the distance between nozzle and bed is above 6mm)

G1 Y-50 (but the distance between nozzle and bed is above 6mm)

Why it doesn't make z axis go up/down while moving in x/y direction to compensate the tilt?

Thanks!

sounds like you might need to adjust your calibration before you autolevel.

follow directions for repetier.

I have read the directions and adjust my calibration again.

now my printer is working!

thanks!