Proofread needed for G/M codes in reprap.org

neveroddoreven

I've updated the big cheat sheet of Gcodes on reprap.org. These values were poorly documented in Repetier.ino, and spottily described in the Repetier Firmware Z-probing tutorial. I dug into the sources and found the real behaviors as best I could.Someone with better knowledge, please review the edits and adds I made in these RepRap Gcode documentation sections:http://reprap.org/wiki/G-code#G29:_Detailed_Z-Probe http://reprap.org/wiki/G-code#G31:_Set_or_Report_Current_Probe_status http://reprap.org/wiki/G-code#G32:_Probe_Z_and_calculate_Z_plane http://reprap.org/wiki/G-code#G33:_Measure.2FList.2FAdjust_Distortion_Matrix http://reprap.org/wiki/G-code#M320:Activate_autolevel.28Repetier.29 http://reprap.org/wiki/G-code#M321:Deactivate_autolevel.28Repetier.29 http://reprap.org/wiki/G-code#M322:Reset_autolevel_matrix.28Repetier.29 http://reprap.org/wiki/G-code#M323:Distortion_correction_on.2Foff.28Repetier.29

Repetier

Thanks for updating. It looks quite good. Only thing I think is wrong is your comment about homing to z max. That only happens for delta printers, all other printers should not home to z max in latest releases. Older versions might do that.

fanofcc

Really? I'm using homing to Zmax in my cartesian (RF 0.92.8) and seem very fine.

Could you tell me why should not in latest release?

Repetier

z max homing is always best.But in cartesian printers if you homed before probing you can compute new z length from measured difference, no rehoming to z max is needed. Some users complained that is is just waisting time, so we replaced it by mathematical correction.

Privacy Policy | About Us