After calibrating towers

boubouexpress

<div>
</div>I get a huge lag of 20 mm between z and x, y

Repetier

What did you do?

boubouexpress

delta RADDS driver stepper 128 nema 17 400 steps

Z length 572

Horizontal radius when centered 187.38

Max. horizontal radius 110

Correction radius 70

X,Y,Z axis stepper motor

Resolution 1280

firmware 0.92.9

M502

M321

G28

G1 Z150

G131

M99 X0 (calibration rod)

M99 Y0 (calibration rod)

M99 Z0 (calibration rod)

G131

G132 S1

Repetier

M502 makes only sense if you store the overridden data with M500 afterwards.

Your seconds M131 is too much, but should do nothing.

After that G28 should have them on same height, so

G28

G1 Z150

G131

should have all rods match same height as measured with rod, right?

boubouexpress

error

M321

G28

G1 Z150

G131

M99 X0

M99 Y0

M99 Z0

G132 S1

"should have all rods match same height as measured with rod, right?" ??? right

Repetier

Good to hear it is working now:-)

boubouexpress

I despair

always the problem with version 0.92

no problem version 0.91

Repetier

But what is your problem at all? You said height match with my test so that part is working. So what is not working?

boubouexpress

video

Repetier

Does your extruder have a offset in xy? Looks like it from the video so that is ok. You should go more down after homing to make sure the left endstop is not hit when selecting the extruder. I always set z back on home to 50mm. Printing in top height is nearly impossible as objects must have very small size and be exactly at center to be printable.

boubouexpress

toujour the same bad calibration problem

10 mm plate

more than 5 mm gap endstop sur x, y

m321

g28

g1 z10

g131

m99 x, y, z

g132 s1

boubouexpress

i position the endstop perfectly equal to the plate

M321

G28

G131

G132 S1

g32 S2 G33

perfect impression tray test

where does the calibration problem of the plate 10 mm

Repetier

Distance to endstops after homing must not be the same. That depends on your printer geometry and hall sensor sensitivity. As long as my test G28 G1 Z100, G131 works everything is fine and you can start calibrating the printer. Till G132 you have only calibrated homing position.

what is "perfect impression tray test"

what does "where does the calibration problem of the plate 10 mm" mean? I guess you have not calibrated geometry but without information I can not say.

boubouexpress

I am sorry my English

not explain well

why the same configuration

works perfectly 0.91 and not with 0.92

except G33 for 0.91

for me it is the g131et 132 g S1 does not work in 0.92