Wipe tower position

phil135

I use repetier-host 2.3.2 with prusaslicer 2.9.4 ; my problème is that i can't use the wipe tower as it is always outside the print area.
I tried to adjust the printer description (prusa i3, 2 extruders) in repetier, but obviously the information is not transmited to prusaslicer.
I also tried to first transfer print parameters , then go back to prusa slicer and move the tower with the mouse, and then slice ... but without any better.
what do i miss ?
thanks

Repetier

You need to define wipe tower position in print settings in Prusa Slicer and save that configuration. Host does not change the position just selects the profile. When it then slices with correctly saved position in profile it should appear exactly there. When you just move it in slicer and then leave the settings get not saved and position ignored.

phil135

i'm sorry but now when i activate wipe tower i have the message:
The cleaning tower currently supports insoluble supports only if they are printed with the current extruder without triggering a tool change. (support_material_extruder and support_material_interface_extruder must be set to 0).
Adjust these settings to enable the cleaning tower?
... but i have 2 separated extruders
note: i didn't had this message previous days
bye the way, i can't find the "position" setting. do you have a picture/screen copy?

phil135

well ... finally i went back to prusaslicer 2.8.1 ; settings are easier to find