Repetier You can set STEPPER_HIGH_DELAY and double step delay, so you can adjust to your stepper needs as long as they need enable/dir/step signal. In config tool you need to enable advanced mode to see the timing fields.
boelle if i find the right values can my board be added as a selection in the drop down? if its not allready there
Repetier Is this a sold board?Boards do not contain timing data, so the extra delays are not set by selecting the board.
boelle of course its a sold one, but if the timing data are not set by selecting the board it does not matter
Repetier On esolution is to offer the config tool Configuration.h as a starting point. That would have set the timings correctly for users to start.
