Backlash

DBSDBS

When I setted up precisely the stepps for X and Y motors, I marked that I have 0.15mm BackLash for Y... This is very strange, because I use a belt drive, but the fact is a fact. I tried to compensate it enabling BackLash compensation in the firmware. I put 0.15mm in the sell and flashed the firmware. The BackLash value lowers to 0.05 mm, but still exists. After that I add additional 0.05 to 0.18 and put 0.22 mm in the firmware... Nothing changed...

Repetier

Please check what eeprom says about backlash. I think it is stored in eeprom overwriting config settings.

DBSDBS

#define ENABLE_BACKLASH_COMPENSATION 1

#define X_BACKLASH 0

#define Y_BACKLASH 0.22

#define Z_BACKLASH 0

This is from a Configuration.h

Repetier

Yes, but what is your eeprom saying. As I said with eeprom support is is not relevant what you write in config. Connect with repetier host and open eepsom settings to change values.

DBSDBS

Thank you very much! All is OK now.