Hot to set #define Z_PROBE_X1 ?

dinizhobby · 2016-03-25T19:04:37+00:00

Do not start testing from top, that might cause problems. G32 for example homes, goes down and measures then.2. Check values in eeprom. Coordinates + probe o...

dinizhobby

Hi Guys,

How do you define these values in the firmware? I have Kossel Alt

#define Z_PROBE_X1

#define Z_PROBE_Y1

#define Z_PROBE_X2

#define Z_PROBE_Y2

#define Z_PROBE_X3

#define Z_PROBE_Y3

I tried some value , but alway got this erro below

15:50:28.001 : Warning:Invalid delta coordinate - move ignored x:2400 y:3000 z:4008

If you give G29 command moves it to the point y20 y20 and repeat movement in the same place a few times. does not leave it.

Repetier

Do not start testing from top, that might cause problems. G32 for example homes, goes down and measures then.
2. Check values in eeprom. Coordinates + probe offset must be inside printable radius or you get that error.
3. Positions should build a quadratic grid if you measure a grid with X1/Y1 the left/lower origin or 3 points near towers if you use 3 point measurement.

dinizhobby

Hi

But how do I set these coordinates? I did not understand how to catch these coordinates.

#define Z_PROBE_X1

#define Z_PROBE_Y1

#define Z_PROBE_X2

#define Z_PROBE_Y2

#define Z_PROBE_X3

#define Z_PROBE_Y3

Repetier

Whats the problem? Just put the coordinates behind

#define Z_PROBE_X1 100

or change them in eeprom.

dinizhobby

I want kown how get these coordinates in my printer. I dont kown how get them.

dinizhobby

Can you help me? I just want know how to get these coordinates correct.

Repetier

Select coordinates closer to the printer center. You have set a max. printer radius which must also be smaller then horizontal radius. That is the radius of allowed coordinates. Then make sure position+ z probe offset lies within that radius.