Home Position

Scet

Hello, I've got a quick question here.

When I press the home position button, should the motor move until it hits the endstop or it only register the current position as the home position?

Repetier

Homing goes to endstops typically for the axis selected. Simple G28 will home all axis at once.

Scet

hmm strange, in my case. The axis doesn't move to the endstop when I press the home button but it register the current position as the home instead. May I know what might be the source of the problem?

Scet

Found the problem, it seems that I forget to comment out this line.

#define DISABLE_MIN_ENDSTOPS

Now everything works perfectly. Thanks

Repetier

Does not look like Repetier-Firmware:-)

Scet

Well, I'm using Marlin Firmware but I run it in Repetier-Host