M505 ROD_RADIUS is not set to default factory settings.

Good Evening

Repetier-Firmware 0.92.8 version

<div>I use</div>M502 for revert to the default factory settings.

but the ROD_RADIUS is not set to default factory settings.

Is a mistake ?

thank you

Sandro

Because in Configuration.h is recommend set it to 0 "CARRIAGE_HORIZONTAL_OFFSET" and "END_EFFECTOR_HORIZONTAL_OFFSET" ?

thank you

Sandro

<div>/* =========== Parameter essential for delta calibration ===================

C, Y-Axis

| || CARRIAGE_HORIZONTAL_OFFSET (recommend set it to 0)

| | ------------------------------------------

|_________ X-axis | \ |

/ \ | \ DELTA_DIAGONAL_ROD (length) Each move this Rod Height

/ \ \ is calculated

/ \ \ Carriage is at printer center! |

A B _____/--------------------------------

|--| END_EFFECTOR_HORIZONTAL_OFFSET (recommend set it to 0)

|----| ROD_RADIUS (Horizontal rod pivot to pivot measure)

|-----------| PRINTER_RADIUS (recommend set it to ROD_RADIUS)

Column angles are measured from X-axis counterclockwise

"Standard" positions: alpha_A = 210, alpha_B = 330, alpha_C = 90

</div>

Thanks. Problem is fixed now.