Z Probe homes after every measurement

Parkush

Hi

I finally got 0.92.8 running on my Rostock Max v2 so I could start z-probing.

But after every measurement the printer homes at z-probe speed, before changing to the new coordinate. Sometimes it sounds like it grinding at the top.

It must be one of my settings?

// #################### Z-Probing #####################

#define Z_PROBE_Z_OFFSET 0

#define Z_PROBE_Z_OFFSET_MODE 0

#define UI_BED_COATING 0

#define FEATURE_Z_PROBE 1

#define Z_PROBE_BED_DISTANCE 25

#define Z_PROBE_PIN ORIG_Z_MIN_PIN

#define Z_PROBE_PULLUP 1

#define Z_PROBE_ON_HIGH 1

#define Z_PROBE_X_OFFSET 0

#define Z_PROBE_Y_OFFSET 0

#define Z_PROBE_WAIT_BEFORE_TEST 0

#define Z_PROBE_SPEED 20

#define Z_PROBE_XY_SPEED 150

#define Z_PROBE_SWITCHING_DISTANCE 2

#define Z_PROBE_REPETITIONS 3

#define Z_PROBE_HEIGHT 11.78

#define Z_PROBE_START_SCRIPT ""

#define Z_PROBE_FINISHED_SCRIPT ""

#define Z_PROBE_REQUIRES_HEATING 0

#define Z_PROBE_MIN_TEMPERATURE 150

Repetier

Check #define Z_PROBE_BED_DISTANCE 25 in eeprom. For G32 it should home go to 25mm above bed and then always move back to that height not top.

Parkush

The setting is in eeprom. I've double checked ...

Parkush

But I do not run G32. I run the bed right map through the menu.

Repetier

That is a different thing. For bed height map (which changes nothing just measures) go manually to Z=25 and then start. It will always start at current height and nozzle will always go back there.