dual extruder and Repetier-Firmware configuration tool for version 0.92.8

Alberto

hello

dual extruder and Repetier-Firmware configuration tool for version 0.92.8 you can not run a second heater (Heater pin: 2 heater normally used for extruder 1)
Hardware:
ramps 1.4 and LCD2004
can someone have a similar problem?
version of 07/12/2015 everything works

Repetier

RAMPS + Heater for extruder 2 can collide with fan which uses the same pin. Make sure fan uses a different pin or disable fan usage.

blastactionhero

hello,

how i make sure that the fan use a different pin or how i could disable the fan usage?

best regards

blastactionhero

i had set in the configuration.h the line "
//#define FAN_PIN 4 // Extruder 2 uses the default fan output, so move to an other pin"
as"
#define FAN_PIN 4 // Extruder 2 uses the default fan output, so move to an other pin"

could you please help?

best regards