No response after shutdown

Landin81

Searched the forum but didnt find anything about this =/

I have a Da vinci 1.0A and just installed the repetier 0.92
Im running simplify3d software.

After I close s3d or press the disconnect button, or shut of the printer and than start it again or connect s3d to the printer, the only thing I get is M105 codes.

The only thing to get it to work is to delete the Arduino due drivers from my port, and reinstall them, than it works again until I shut it down. This is so annoying!

please help!

EDIT: When just sending the M105 codes, I can still controll the printer with JOG-controlls, but I get nothing back from printer, its like a one way communication.
I have tested different budrates also.

Repetier

When you can control from pc the baudrate should be ok.

I find it strange that deleting and installing the driver helps. Never had that a driver needed reinstall. But that is something on the pc side so it is not a firmware related problem if that is all you do.

Have you tried using our host for communication and check the log. I'm not familar with s3d connection.

Landin81

Thanx for answer!
Yes I have also tested the repetier host and its the same issue.

Before I flashed the printer with 0.92 and running the stock firmware, there were no communicationproblems at all, so I dont know if its only on the computer =/
<blockquote rel="Repetier">When you can control from pc the baudrate should be ok.

Have you tried using our host for communication and check the log. I'm not familar with s3d connection.

Landin81

Problem solved:
Reinstalled windows. There was some conflicts between other usb to serial protocolls that I have use for arduino.

Thanx for any help =)