RH 1.5.6 refuses to park after job.

Stoutlimb

Since upgrading from 0.9, I have had to set RH to make a sound after printing, so I can rush and push the park button. All my jobs now have a heat scar on top. As far as I can tell, the "Printer Settings>Printer>Go to park position after job/kill" checkbox is just a placebo.

Caboose

Same problem here. I've seen it was a problem before and I read that you're supposed to manually put in G28 at the start of every job, I'm just not sure how to do that.

Repetier

In printer configuration you have scripts. Put in end job something like

G1 X0 Y0 F12000

to get the extruder out of the way fast.

Then

G1 Z<zmax> F600

to move it up. This replaces the park function. Park only works under certain conditions like it must be homed while connected or it will ignore it.

Stoutlimb

Downgrading to 0.90D fixed my problems. Is there any reason you can't copy/paste the code from 0.90D to make it work properly again?