Ender3 S1 Pro and progress status issus

Calabrone

Hi there, i print with success on my Ender3 S1 PRO but the printing progress status is not available on the display: it's stuck on 0% with no ETA for all the printig time. Is there any configuration i must to set up on repetier server? I've noticed also that the home command perform in different way when lounched form repetier, so maybe am i using a wrong configuration? I've setted marlin firmware on the setup.

Thank's in advance

Repetier

It really depends on what you see on ender display. When you send
M117 Hello
do you see that at same position? Then info comes from server sending M117 with layer/eta/...

If not it comes likely from M73
https://marlinfw.org/docs/gcode/M073.html<br/>so check if sending it changes display and check print log if we send it.

If M115 returns

Cap:PROGRESS:1
we would also send
<div><pre>M532 X{f:progress} L{i:currentLayer}

</pre></div>

Calabrone

Both commands M117 and M73 seems to have no effect.
With M115 i got

Cap:PROGRESS:0

Maybe my display is not supported? It's a touch display.

Repetier

That is possible, especially if printer has a graphic display they use often a own solution only showing progress with sd card printing and never show messages send with M117.

Calabrone

Repetier said:

That is possible, especially if printer has a graphic display they use often a own solution only showing progress with sd card printing and never show messages send with M117.

Yes i confirm that is a graphic display. So i suppose there's no solution, right?

Repetier

I guess that is how it is. Firmware gives us no access to that display.