autoleveling delta

lazy_mosquito

Hi,

I am trying to get the autolevelling working.

I am using firmware 0.92 have a delta and a mechanical endswitch installed as a probe.

When i check the probe with the G31 command i get L when not pressed and H when pressed. So the probe is working.When i give command G30 the extruder crashes down in the bed.

in the firmware i have the following settings.

#define Z_PROBE_Z_OFFSET 0

#define Z_PROBE_Z_OFFSET_MODE 0

#define UI_BED_COATING 1

#define FEATURE_Z_PROBE 1

#define Z_PROBE_BED_DISTANCE 10

#define Z_PROBE_PIN ORIG_Z_MIN_PIN

#define Z_PROBE_PULLUP 1

#define Z_PROBE_ON_HIGH 0

#define Z_PROBE_X_OFFSET 0

#define Z_PROBE_Y_OFFSET 0

#define Z_PROBE_WAIT_BEFORE_TEST 0

#define Z_PROBE_SPEED 2

#define Z_PROBE_XY_SPEED 300

#define Z_PROBE_SWITCHING_DISTANCE 1

#define Z_PROBE_REPETITIONS 2

#define Z_PROBE_HEIGHT 52

#define Z_PROBE_START_SCRIPT ""

#define Z_PROBE_FINISHED_SCRIPT ""

#define FEATURE_AUTOLEVEL 1

#define Z_PROBE_X1 20

#define Z_PROBE_Y1 20

#define Z_PROBE_X2 200

#define Z_PROBE_Y2 20

#define Z_PROBE_X3 180

#define Z_PROBE_Y3 200

#define FEATURE_AXISCOMP 0

#define AXISCOMP_TANXY 0

#define AXISCOMP_TANYZ 0

#define AXISCOMP_TANXZ 0

Anybody any ideas why the extruder doesn't listen to the probe?

lazy_mosquito

Solved: z-length too long

Repetier

Makes sense. z probe is only used while probing not while moving to probe position. Thanks for the feedback.