How do execute GPIO commands before and after a job?

fbrier

I would like to cause a set of GPIO pins high before a job, and once it is complete, set them low. Ideally it would be great for whatever script is setting the pins high could scan the gcode of the job. Based on whether a specific comment was in the gcode, that would effect which pins were set high. I would also like to read a GPIO value and if it is high, open a dialog in the web interface to warn the user. Is this possible with Repetier-Server? How and where do you create the pre and post job handlers? Thank you.

Repetier

Adding code is easy. In Printer configuration->GCodes->event dependent are codes for before print, after print and do not forget stopped print in case it was aborted.

Commands for enabling them are in global settings->gpio visible and depend on name you gave the pin.
With our computed expression you can also check if it was already high. Something like this:

@if {{get_gpio_state('nameOfGpio')==1}}
@info "Pin was already high"
@pause PinHigh
@endif

gulshan212

Hello, this is Gulshan Negi
Well, In Repetier-Server, you can achieve your desired functionality by utilizing the event system and scripting capabilities. Repetier-Server provides event handlers that you can use to execute custom scripts before and after a job.
Thanks