Hallo,
ich habe v1.4.2 gerade frisch installiert und wollte über das Anlegen eines Druckers nach Auswahl der Firmware "Klipper" dann Klipper installieren, aber die Installation hängt hier:
Selecting previously unselected package libgcc-8-dev:armhf.
Preparing to unpack .../10-libgcc-8-dev_8.3.0-6+rpi1_armhf.deb ...
Unpacking libgcc-8-dev:armhf (8.3.0-6+rpi1) ...
Selecting previously unselected package gcc-8.
Preparing to unpack .../11-gcc-8_8.3.0-6+rpi1_armhf.deb ...
Unpacking gcc-8 (8.3.0-6+rpi1) ...
Selecting previously unselected package gcc.
Preparing to unpack .../12-gcc_4%3a8.3.0-1+rpi2_armhf.deb ...
Unpacking gcc (4:8.3.0-1+rpi2) ...
Selecting previously unselected package libstdc++-8-dev:armhf.
Preparing to unpack .../13-libstdc++-8-dev_8.3.0-6+rpi1_armhf.deb ...
Unpacking libstdc++-8-dev:armhf (8.3.0-6+rpi1) ...
Selecting previously unselected package g++-8.
Preparing to unpack .../14-g++-8_8.3.0-6+rpi1_armhf.deb ...
Unpacking g++-8 (8.3.0-6+rpi1) ...
Selecting previously unselected package g++.
Preparing to unpack .../15-g++_4%3a8.3.0-1+rpi2_armhf.deb ...
Unpacking g++ (4:8.3.0-1+rpi2) ...
Selecting previously unselected package make.
Preparing to unpack .../16-make_4.2.1-1.2_armhf.deb ...
Unpacking make (4.2.1-1.2) ...
Wie stelle ich fest, ob Klipper installiert wurde? Kann ich die Installation nochmal anstoßen?
