Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
All Discussions
Something wrong in that Z LEVELING TUTORIAL https://www.youtube.com/watch?v=L9URtv2LqKc
Davinci xyz anything higher than 5mm starts to click and will not extrude, not a clog, not bed level
I can't get no extrusion :(
Extruder motor vibrates but does not move.
Host wont run on Windows 8.1 64bit
No Start signal detected
Firmware compiler error RETRACTION_UNDO_EXTRA_LENGTH
Useing a sd card
Extruder temperature unreliable
RH 1.5.6 refuses to park after job.
SD Card Reader Setup
software revision
G-code plugin parsing on upload
Can you move settings to a new computer...
RepetierHost 1.5.6 and Slic3r 1.2.9 incompatibility
RepetierHost v1.5.6 & Slic3r 1.2.9 on Linux - Configuration button not working
Problem with heating during print.
printrbot simple netal config files
Z-probing trouble
Little help here!
« Previous Page
Next Page »
Privacy Policy
|
About Us
