Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
All Discussions
update to repetier host?
Thin Wall settings ??
Z offset in EEPROM config
Re-purposing a 3D printer board to control a solenoid valve with Mcode
E3D Cyclops configuration in 1.0.2
CoreXY laser slow short moves
Pin assignment changes
New setup Z homing crashes into bed
Repetier Host 2.0.5, Marlin Firmware 1.1.8, Gt2560
Print command
Multiple z axis lead screws
Printer Settings - Home X/Y/Z has no drop down selection
delta firmware
Compatibility with M3D Micro - original
Firmware spped axys Z
Over Extrusion Issue
Z-Probing error reading diagonally with the grid
core xy moving strange on axes
Excessive z axis movement at start.
windows 8 connects but have no manual control and printer not reporting back to computer.
« Previous Page
Next Page »
Privacy Policy
|
About Us
