good_idea
work245@mail.ru
I might help with MKS Gen-2Z v1.1 board
About
- Username
- good_idea
- Joined
- Visits
- 58
- Last Active
- Roles
- Member
Comments
-
Liebe Kollegen, everything works fine and Zmin stop located 2 mm below the print surface has already saved my hardware several times during my experiments with auto leveling. THANK YOU VERY MUCH! If you don't mind I have one more question. The pri…
-
Thank you very much fuer Erkalaerung, ich gehe jetzt diese 0.33 mm suchen. :-)
-
Did I understand you correct: To have homing, bed auto leveling and protecton against sensor failure three different pins should be used, like this: Z-max endstop is connected to Z-max pin and I am homing there. Capacitive sensor is connected to …
-
Thank you. I read that dozens of times. But it does not work out. See how I do it and show me, please, where I understood your instructions wrong way. Prusa acrylic. No hardware Z-stops, neither min, nor max. Capacitive sensor is connected to Z-mi…
-
-
Can anybody, please, make a picture of where does the above equation come from?
-
It's a bit confusing above: what is Zfit and what is Zlose?