Doug40
About
- Username
- Doug40
- Joined
- Visits
- 117
- Last Active
- Roles
- Member
Comments
-
I am not able to do what you suggest using the configuration tool. Using the Config tool, I can set Ext 1 heater and sensor as you suggest, but these settings are not present if the mixing extruder flag is checked. The Extruder 1 settings that rem…
-
That seems like the perfect way to handle the priority issue. At the same time, it seems to me that it would be desirable to have the configurator set the cache sizes as high as the processor board selected would permit, providing the selection ca…
-
Update:Since raising the priority of Repetier Host in the OS and increasing the cache sizes in Repitier FW, the momentary pauses, and resulting blobs on the surface of prints that I used to see have all but been eliminated. I raised the priority of…
-
Thanks for confirming my suspicions. I found out that it takes longer to kill a job, so now I just press the reset on my LCD panel to stop it. Also, raising the number of moves that remain before the FW starts to slow down the moves seems like a g…
-
I'm aware of the mouse movement termination. The real problem is that in my machines the time-out is only 5 seconds, even if you hold the mouse rock steady. That's enough for a phrase of a short sentence, but not enough for some of the lengthy tip…
-
I'm not sure I understand your question, but my printer uses a GT2560 control board. The configuration.h file in my Marlin FW that came with it calls it an unltimaker, and the resources exactly match the ultimaker shield 1.5.7 in the list of Mother…
-
When it comes to the motherboard selection, I found the Ultimaker Shield 1.5... was an exact match to the items in the Marlin firmware that came with it. For my printer, the display was the ...reprap discount...... or something like that. If you h…
-
That worked for me on my Geeetech I3 printer.